The most important thing to use the elevator is regular maintenance, which is most easily ignored by many auto repair shop owners! There are many maintenance-free designs for lifts, though. But there are still some things that need regular maintenance, in fact, they have been listed in the manual, you can operate according to the requirements of the product manual. Therefore, the lift is here to remind you again that in order to ensure the stability of the lift and extend the service life, regular maintenance, regular maintenance, regular maintenance should be insisted on!

To perform the following tasks on a monthly basis:

one Tighten anchor bolts, torque 150 Newton/m;

2. Check all joints, bolts or pins to ensure good connections;

3. Grease the slide, chain and wire rope;

4. Visual inspection of all hydraulic lines for wear and oil leakage;

5. Check that the safety mechanism is in good working order;

6. Lubricate all pulleys and pins with 90Wt gear oil;

Note: All anchor bolts need to bear normal torque. If a bolt cannot bear normal force, stop using the lift until a qualified bolt is replaced.

The following work is required every six months:

one Visually inspect all moving parts for possible wear, dryness and damage;

2. Check and adjust the tension of the wire rope according to the situation to ensure the parallel operation of the lift;

3. Check whether the column is perpendicular to the ground;

4. Check the rubber support pad and replace it if necessary;

5. Check whether the safety protection device is in normal working condition.

Wire rope inspection and maintenance:

All hoisting ropes should be replaced every 3 to 5 years, or when damage is visible. As long as the wire rope is properly maintained, the service life of the wire rope can be extended. For example, use 90Wt gear oil lubrication or wire rope lubricant to lubricate wire rope! These oils/lubricants go deep into the fibers to prevent damage. The lift is recommended to be lubricated every 3 months (4 times a year). At the same time, print the maintenance schedule and post it in the maintenance workshop to remind the next follow-up time at any time.

Every working day, as far as possible, any visible part of the wire rope should be observed in order to find damage and deformation. When the wear, broken wire, broken strand, rust, stretching, bending, deformation, fatigue, diameter, rope core exposure, etc. of the rope meet the replacement standards stipulated in the relevant regulations, please replace the new rope in time, otherwise it will face risks.

Regular maintenance can ensure the normal use of the lift, reduce the failure rate, extend the service life of the lift, so as to ensure the normal maintenance work.